What is the biggest amount of data that CD can hold?

The  CPU Performance can be improved via ___________.

half adder is a Combinational logic circuit that aims to

Memory and counters could be considered as examples of

A computer________ is most often concerned with__________: How long does it take the system to carry out a task ?

__________offloads I/O processing to a special-purpose chip that takes care of the details.

Which of the following disk technology its access time and transfer rates are typically 100 times faster than magnetic disk ?

In MARIE, the registers are

The clock in computer helps to

Monolithic systems provide

The “universal gates” are

Flynn’s Taxonomy takes into consideration the and the paths incorporated into an architecture.

Number of processors / number of data paths Q13: In the 9’s Decimal Complement, if the first digit is (0 through 4), that means the number is

For a 4-Digit Numbers, the 10’s complement of 261 is

_________chips consist of programmable AND gates connected to a set of fixed OR gates.

IBM’s Millipede is an example of_________

____________allows the CPU to do other things until I/O is requested.

A stateful application requires________

Interconnection networks are often classified according to___________.

______________cannot be accessed randomly.

Which of the following is NOT a function of the I/O processors ?

HALT instruction requires__________.

For a 2-Digit Numbers, the 9’s complement of 2 is

In_________________, program control is directly controlled by data dependencies.

Some CPUs divide the Fetch-Decode-Execute cycle into smaller steps, and these steps will be executed in parallel way, and this is called________________.

_____________is where the data is located in a register.

__________is used to build cache memory.

Which of the following hexadecimal number is equal to the decimal number "51" ?

A___________ consists of a set of nodes that hold the states of the machine and a set of arcs that connect the states.

The SPEC CPU benchmark evaluates__________.

In____________, jobs are serviced in arrival sequence and run to completion if they have all of the resources they need.

Byte is unit of storage measurement, and 1.5 Terabyte equal to___________.

A_____________ selects a single output from several inputs, which is determined by the value of the multiplexer’s control lines.

_______________translates mnemonic instructions to machine code.

________is responsible about  executing  the instructions  and  places  results  in registers  or  memory.

__________ multiprocessor systems have physically separate memory.

________________aims to speed up accesses by storing recently used data closer to the CPU, instead of storing it in main memory.

Which of the following is NOT of prevalent rhetorical fallacies that encounter decision-makers during purchasing new hardware or system software ?

Which of the following mean methods is applied for skewed data ?

______________is the elapsed time between the occurrence of an interrupt and the execution of the first instruction of the Interrupt Service Routine (ISR).

In Amdahl’s Law “K” represent___________.

Which of the following octal number is equal to the decimal number "19" ?

In embedded system, events can happen___________.

Which of the following is NOT a characteristic of RISC ?

Which of the following approaches use the same approach that applied in vector processors ? A.MIMD

The integrated circuit technology was used for developing computer in A. Zero Generation

Which of embedded hardware category provides minimal hardware customization ?

_____________are real computer systems that support the operation of a device (or machine) that usually is not a computer.

Which of the following is NOT a component of I/O subsystems ?

STORE and LOAD instruction can be categorized as_________.

Connections are short, and the design is simple and scalable. They are robust, efficient, and cheap to produce. They are, however, highly specialized and limited as to the types of problems they can solve. These are the characteristics of_______.

The Simplified form of the A = F - (E + F + G) expressions is___________.

Which of the following approaches has been expanded to include shared memory and distributed memory ?

includes topics such as pipelining, parallel execution units, and integrated floating- point units.

DRAM refers to__________.

The operating system determining which process shall be granted access to the CPU, and this is the

_________enhances the performance by providing faster memory access speed.

DRAM is a “cheap” memory, and that because of___________.

A___________ is a product term that contains all of the function’s variables exactly once, either complemented or not complemented.

Which of the following is NOT characterization of Branch prediction ?