Used to protect liquid system from excessive pressure

An automatic device that remove gases and condensate from steam lines and heat exchanger without the loss of steam.

A banging condition that is caused by steam and water mixing in a steam line.

It is a pump that supplies water from demin tank to condenser.

Is an equipment used to remove dissolved gases in a feedwater

Is a pump that transfer feedwater from deaerator to steam drum

Is an equipment used to remove ash deposits from tubes in the backpass area

Preheats the air used for combustion in the furnace.

Uses a high voltage charge to collect dust particles from flue gas.

Used to supply turbine and generator bearing oil.

Is used to supply control oil in the main valves and emergency trip signal.

Equipment that removes non condensable gases from condenser.

Equipment that condenses the gland sealing steam.

Is a reservoir of water/steam at the top end of the boiler.

Regularly cleans the condenser tubes from impurities that would adhere to the tube that causes inefficient heat transfer that reduces condenser vacuum.

Is a pump that supplies demineralized water to closed cooling water heat exchanger.

Is an additional filtration that removes the heavy debris in seawater.

Is controlled to provide required excess air according to the solid fuel flow.

Largest fraction of the total ___ supplied to the combustion during normal operation is being done by primary air fan.

Primary air fan that supplies ____ to the fuel chutes between the furnace isolation slide gate valve and the furnace qweqeqwe.

Secondary air fan supplies stagnation combustion air to furnace air ports and combustion air to the _____

Fluidizing air supplied by the FAB is used to provide _____ to the cyclone and the seal pot.

The IDF is installed between ___ and stack.

Accumulates the saturated steam from the continuous blowdown line coming from the steam drum.

It stores the blowdown water and water coming from the different drains of the main water and steam system.

Is the continuous removal of water from the boiler to improve water quality as dissolved solids get above its set parameters.

Purging air is used as purging medium for cleaning of the oil lance after a burner stops in order to avoid any oil residue inside the lance that would lead to the formation of ____

Plant air is used as a ____ air and is essential to operate the burner with diesel oil.

It monitors combustion in the furnace and is suitable in monitoring flames for a variety of fuels and combustion processes.

Delivers diesel oil to the SUB by spray mechanism

Is a high rate settling process that combines the advantages of ballasted flocculation and lamella clarification.

Kaya ko kayong ipasa, pero kaya ko rin kayong _____.

Sinong paborito mong bantay?

Acts a a glue or paste in actiflo

Is used to reduce the level of suspended solids such as silt clay and organic matter in pre treatment process.

Is the process of removing organic compounds in activated carbon filter.

Is a technology used to remove large majority of contaminants with the need of external pressure.

Is where the acids and alkalis are rendered harmless.

Consist of small particles of silt clay organic matter algae.

It treats water that has low traces of contaminants. Its secondary effect is to qweqwqwe