Which of the following rooms is NOT classified as a habitable room?

Which of the following rooms is NOT classified as a habitable room?

For safety reasons, ______ type glass is normally used in sliding glass doors.

The hatch pattern or poche of a wall with a continuous "S" shape indicates __________.

When using a single door to cover the entire opening of a double car garage, the door is commonly 16 feet wide and is typically ____ feet high.

______ windows are hinged at the top and swing outward.

_______ windows are hinged at the bottom and swing inward.

A ______ window has a lower panel that slides upward.

Door and window schedules are used to more specifically describe them and to keep the drawing clean of unnecessary notes.

A window size designation of 8ºx5º indicates a width of 8 feet 0inches and a height of 5 feet 6 inches.

Bathrooms, kitchen, utility rooms and the garage are all classified as service areas. They should be designed so that noise generated by plumbing, appliances and etc., do not interrupt activities of the living and sleeping areas.

The lower kitchen cabinet is ____ inches deep and 36 inches high.

________ doors are often used between a kitchen and eating area to provide for some privacy as well as easy passage when transporting materials from one area to the other.

The upper kitchen cabinet is ___ inches deep.

For safety reasons, _____ type glass is normally used in sliding glass doors.

The true size of a 2x6 is ________.

The minimum door size for a bedroom is 2'-6" x 6'-8". This is commonly represented on the plans with a specific note _____ placed next to the door.

If the tops of windows are at the normal 6'-8" height, windows with a vertical measurement in excess of 3'-6" may interfere with the kitchen counter top.

A window size designation of 8056 indicates a width of 8 feet 0 inches and a height of 5 feet 6 inches.

The abbreviation G.D. identifies the:

Which of these is not a typical shape of stair configurations?

_________windows provide a louvered effect.

The floor plan represents a section view of a residence which has had an imaginary cut made approximately 4 feet above the floor line

Residential floor plans are generally drawn at a scale of:

Exterior doors that exit onto a concrete platform or step are normally drawn showing a sill or threshold on the outside of the house.

Interior doors are normally shown swinging into the room being entered and against the adjacent wall.

Pocket doors should not be placed in exterior walls because of insulation displacement nor should they be placed in areas where electrical or plumbing materials will have to be housed in the pocket cavity.

When complete access to a closet is desired ____ type closet doors are normally used.