Which of the following is a characteristic of renewable energy sources?

They can be naturally replenished

They are found only in specific locations

Which of the following is a characteristic of nuclear energy?

It produces low greenhouse gas emissions

It generates large amounts of waste

Which of the following is a method of harnessing geothermal energy?

Hot water from the Earth's crust

What is the primary advantage of using solar energy?

It is renewable and reduces greenhouse gas emissions

It is expensive and difficult to maintain

What is a significant environmental concern associated with the use of fossil fuels?

Air pollution and climate change

Phase 3 Sources of Renewable and Non-Renewable Energy

PHOTOSYNTHESIS LIGHT DEPENDENT REACTION 1. Photosystem II (PSII) – Light Absorption & Water Splitting • Light energy (photons) excites electrons in chlorophyll molecules. • These high-energy electrons leave PSII and are passed into the electron transport chain (ETC). • Meanwhile, water molecules are split (photolysis) into: o O₂ (released as a by-product into the atmosphere) o H⁺ ions (protons, which build up inside the thylakoid) o Electrons (e⁻), which replace the ones lost by PSII. 2. Electron Transport Chain (ETC) • Excited electrons move through protein carriers embedded in the thylakoid membrane. • As they move, their energy pumps H⁺ ions into the thylakoid space, creating a proton gradient (high H⁺ inside, low outside). 3. ATP Production (ATP Synthase) • The buildup of H⁺ ions acts like a “waterfall” of potential energy. • These protons flow back across the membrane through ATP synthase, a protein complex that acts like a turbine. • This flow drives the conversion of ADP + Pi → ATP, which provides energy for the Calvin cycle. 4. Photosystem I (PSI) • Electrons arriving from the ETC enter PSI. • Sunlight excites them again, boosting them to a higher energy level. 5. NADPH Production • The energized electrons are transferred to NADP⁺. • Along with a proton (H⁺), this forms NADPH, another energy carrier. • NADPH is then delivered to the Calvin cycle to help build glucose. End Products of Light-Dependent Reactions: • ATP (energy source for Calvin cycle) • NADPH (reducing power for glucose synthesis) • O₂ (released into the atmosphere as waste) Light-Independent Reactions (Calvin Cycle) • These reactions do not directly require sunlight. • They occur in the stroma of the chloroplast (the fluid-filled space surrounding the thylakoids). • The inputs are ATP and NADPH (from light-dependent reactions) and CO₂ (from the atmosphere). • The outputs are glucose (C₆H₁₂O₆) and other carbohydrates. Think of the Calvin cycle as a factory that uses the energy and “raw materials” made in Stage I (ATP & NADPH) to build sugars. The 3 Main Steps of the Calvin Cycle 1. Carbon Fixation • CO₂ from the atmosphere enters the chloroplast and diffuses into the stroma. • Each CO₂ molecule attaches to a 5-carbon sugar called RuBP (ribulose-1,5-bisphosphate). • This reaction is catalyzed by the enzyme RuBisCO (Ribulose-1,5-bisphosphate carboxylase/oxygenase — the most abundant enzyme on Earth!). • The result is a short-lived 6-carbon compound, which immediately splits into two 3-carbon molecules called 3-PGA (3-phosphoglycerate). Summary: CO₂ + RuBP → 2 × 3-PGA 2. Reduction Phase • The 3-PGA molecules are “energized” and converted into G3P (glyceraldehyde-3-phosphate), a more energy-rich 3-carbon sugar. • This transformation requires: o ATP (provides energy) o NADPH (provides high-energy electrons and hydrogen atoms). • Some of the G3P molecules will eventually be combined to form glucose and other sugars. Summary: 3-PGA + ATP + NADPH → G3P 3. Regeneration of RuBP • Not all G3P molecules leave the cycle. Most of them are used to regenerate RuBP so the cycle can continue. • This regeneration also requires ATP. • For every 3 turns of the cycle, 5 G3P molecules are recycled to regenerate 3 molecules of RuBP. Summary: G3P + ATP → RuBP The Full Cycle Balance • To make one G3P molecule that can exit the cycle (and later form glucose), the cycle must run 3 times, fixing 3 molecules of CO₂. • To make one glucose molecule (C₆H₁₂O₆), the cycle must run 6 times (since glucose needs 6 carbon atoms). Inputs (for 1 glucose): • 6 CO₂ • 18 ATP • 12 NADPH Outputs: • 1 glucose (C₆H₁₂O₆) • 18 ADP + 18 Pi • 12 NADP⁺ Day vs Night Clarification • The Calvin Cycle is called light-independent, but that doesn’t mean it only happens at night. • It usually happens during the day because it depends on ATP and NADPH, which are only produced in light-dependent reactions (when sunlight is available). Simplified Analogy • Carbon fixation = The factory brings in CO₂ as raw material. • Reduction = Workers use energy (ATP & NADPH) to shape the raw material into useful products (G3P). • Regeneration = Some products are recycled to keep the factory running (RuBP is re-formed). • Output = After enough cycles, the factory produces glucose, the “food” of the plant.

Phase 3/4 unit 1

Phase 3 FC Mini-PreBoard 11 - 85 aytem

Phase 3 Combustion Processes of Fuel Supplied Systems

Phase 3 phonics

Related quizzes

Related quizzes