What tool do we use to drive stakes?

A large, flat, often metal head, attached to a long handle that is used to hammer the unnecessary masonry walls in the construction site.

A tool used to measure loans and any project area. Itis also used for longer distances. It ranges up to 50 meters.

A tool used to drive and pull-out nails.

It is use for tying the nylon string in masonry walls.

A tool used for sharpening stakes

A material used as stake and batter board in staking out building lines.

It used to cut the lumber to be used as stake and batter board.

A tool with a pointed tip on the bottom, suspended from a string and used as a vertical reference line.

It is use for tying the nylon string in masonry walls.

It is necessary to secure from local authorities before construction activity on the site.

In the absence of established corners and boundaries, _________ Engineer’s service is required.

Cutting of trees are limited only to those that will be affected by the construction subject to issuance of permit from what Department?

One of the requirements in the construction embodied in the specifications and contract is to provide the following except for:

It is needed to apply and secure because it is necessity in all kinds of construction.

A device used as a guide of the hand saw in cutting objects to form a miter joint.

A double bevel square used to divide an angle in a complicated work in one setting.

A tool with combination of 45 and 90 degrees in one setting. 

A plain board with a 45 degrees guide fastened on top of the upper board. This device is used in designing patterns, cabinets, and the like.

A tool that is like a try square with a sliding and adjustable blade that could be set to any angle other than 90 degrees.