It is done by touching the electrode on the base metal like scratching a matchstick.

It is done by moving the electrode downward until it touches the base metal, then bringing the electrode up slightly to form an arc.

What method in striking an arc is recommended for the beginners?

The eyes can be protected during the welding operation by using:

Which of the following statement is true about Shielded Metal Arc Welding?

What part of the electrode provides atmospheric shielding to the filler metal?

The by-product of flux is also known as_____.

The diameter of the electrode to be used in a welding operation depends upon the:

Which of the following statement is true about electrode?

The coating of electrode is sometimes called _____.

The electrode which has no coating is called _____.

The common length of electrodes are.

The recommended current setting for electrode E-6013 with a diameter of 1/8 inch is_______.

In electrode coding, the spot color for E-6013 is_______.

In symbol E-6013, 60 means _____.

The third digit in the symbol E-6013, 1 stands for _____.

AWS stands for;

The type of current for E-6013 electrode is

The weld position for E-6013 electrode is

The specification of this electrode is Mild steel. Which of the following electrode fall in this category?

The specification of this electrode is Low hydrogen.

Electrode with extremely low carbon content.

Arc stream is created by holding an electrode approximately______ away from the base metal.

What forms on top of the weld to protect it from contaminants during cooling?

Which of the following statement is true about how flux covered electrode works?

This tool is used to remove the slag.

Electrode is also known as_______.

In the procedure of striking an arc, the arc must be maintained for at least________.

In the procedure of striking an arc, which of the following criteria is acceptable?

In methods of striking an arc,the arc must be maintained for about________.

What is the recommended current setting for using the methods of striking an arc?

What is the recommended work angle and striking end when using the scratching method.

What is the recommended work angle and striking end when using the tapping method.

What method or technique is used to increase the width and volume of beads?

This weaving pattern is often used in flat position weld on butt, tee, and outside corner joints for build-up and surfacing application.

This pattern works with fillet weld in vertical and overhead positions. It can also be used for deep groove welds for the hot pass.

This pattern is used as cover passes in flat and vertical positions.

This pattern works well on flat and horizontal positions.

The movement of uneven flux line that causes an arc to move during a weld is known as______.

Which of the following ways is included in controlling arc blows?

It pushes the molten metal away from the leading edges of the molten weld pool toward the back where it is solidified.

What is the recommended electrode to be used in welding Stringer Bead in Flat Position?

What is the recommended current setting to be used in Stringer Bead in Flat Position?

What is the recommended travel angle and work angle for Stringer Beads in Flat Position?

Which of the following situation causes an Arc Blow?

What is the recommended cure or remedy for Arc Blow?

Which of the following situation causes an undercut?

What is the recommended cure or remedy for undercutting?

What is the recommended angle in striking an arc in horizontal position?

What is the recommended width of bead that should be maintained in welding Weave Bead in Horizontal Position?