What type of weld is approximately triangular cross section joining two surfaces at right angles to each other?

What method or technique is used to increase the width and volume of bead?

What part of fillet weld is the exposed side on which welding was done?

The shape/appearance of the beads which results from the movement of the electrode is called______.

What part of the weld that is melted (molten) due to heat of welding.

The point at which the back of the weld intersects the base metal surfaces is called________.

The angle of an electrode in relation to the surface of a work piece when the electrode is perpendicular to the axis of weld is known as

A weld with protruding capping appearance is known as

What code is used for welding Fillet in Flat Position?

What code is used for welding Fillet in Horizontal Position?

"All welds are inspected for weld defect." This event is done______(of)welding.

"Determine that pre heat requirements are adhered at the time of welding." This event is done_______(of)welding.

"Determine designated electrode for the base metal." This event is done_______(of)welding.

"Check all applicable drawings, specifications, procedures, and welders qualifications."this event is done______(of)welding.

" Materials specification of parts comprising the weldment to determine if it follows required specifications."This event is done_______(of)welding.

"Size of all welds are checked using appropriate weld gauges."This event is done_______(of)welding

"Compare weld preparation of each joint with the drawings."This is done______(of)welding.

"Check assembly dimension and fit up."This event is done________(of)welding.

"Determine that correct welding current and proper polarity are being used."This is done_______(of)welding

"Determine that interpass cleaning by chipping, grinding, and gouging are being done in accordance with procedures."This is done_____(of)welding.

Before welding, metal plates need to be

The simplest and the easiest position to master in welding is

Before electrode is discarded, lenght in millimeter must be

The ideal electrode for depositing root pass in horizontal position is

Which of these characteristics describes the best electrode?

In performing stringer beads, which of these techniques is best?

In fillet welding, what is the specified lenght of tack welds?

Longer arc length will result to

In a multi-pass weld, grinding is only allowed at the

In the multi-layered beads, the number of weld pass can be determined by

What welding defect is the result of too fast travel speed, too high current, and poor electrode manipulation?

Which of the following situation causes arc strike?

What welding defect is the result of wrong electrode weld and faulty preparation?

This welding defect is caused by a great number of passes with small diameter electrodes and slow arc travel speed.

What welding defect is caused by improper welding technique and faulty preparation?

The recommended electrode used in performing T-Fillet joint is

Which of the following tools is NOT appropriate to use in performing T-fillet joint?

Which of the following tools is used to measure the weld beads?

Which of the following procedure is the first step in performing T-Joint in Horizontal Position?

What is the required travel angle and work angle in performing T-Fillet joint in horizontal position?

Which of the following defects occur due to faulty electrode manipulation and too high current?

What welding defect occurs due to improper welding technique and faulty preparation?

What welding defect occurs due to longer arc and large deposits in a single run?

What welding defect occurs due to longer arc length and severe electrode angle?

What welding defect occurs due to improper welding technique and too tight welding area?

Which of these characteristics describes external defects?

Which of these characteristics describes internal defects?

According to American Society of Mechanical Engineers (ASMI),the cause of welding defects with the highest percentage of 41 percent is

Any discontinuity (or irregularity) in the weld metal, which exceeds the applicable code limit, is termed as a

Defects may occur due to the following reasons,EXCEPT;