which of the following checking or Testing Resistors is in correct....... 1.) Read the indicated (color code ) value on the resistor’s body. 2.) Set the VOM to the voltage scale , the range within but not way below the indicated value. 3.) Zero-adjust the ohmmeter by connecting the red and black test leads of the ohmmeter before measuring the value of the resistor under test.

in checking a resistor the Good Indication A resistor is in good condition if its resistance is close to the indicated value.

No meter deflection (infinity) at all ohm scale settings.-The resistor under test is leaky.

used to resist or control the flow of current in a circuit

is an electronic component that has the ability to store electrical charges or voltages. Capacitors were called condenser earlier

give at least one type of capacitor

a capacitor is polarized means that one terminal of a capacitor is positive and the other is negative.

In different circuit arrangements capacitors perform various functions. Depending on these duties capacitors acquire different names which is not include

give at least one defect found in capacitor

when checking a capacitor that has 1000 mf the suggested rage is

is a two terminal device that conducts current more easily in only one direction

We say that a diode is good when two conditions are met. In one test there should be low resistance (current flow) and if you reverse the polarity in the other test there should be high resistance (no current flow).

The positive test prod of the meter is placed to the cathode and the negative to the anode. In this test the diode is reverse biased

an active semiconductor device having three electrodes (terminals).It could perform variety of application as switch, amplifier, oscillator, etc

give at least one kind of transistor

a protective device having a short length of wire that melts when the current passing through it exceeds its rated value

there is no polarity to consider in testing fuse

is a Good transformer indicate that all the terminal coil of the transformer from primary and secondary have the resistance reading of approximately 3-10 ohms

if the primary or secondary winding has zero resistance reading in any of the terminal tested

what electronic equipment is used in checking a component