To be certain that accurate reading are taken, the bubble in the leveling vial of a farm level should be checked:

When one fails to hold the leveling rod up straight, the measurement will be:

When setting up a tripod and a builder's level, the leveling screws should be adjusted until the:

Abby needs to lay out a building using the 3-4-5 method, what measurement is used with 24' and 30' to make a square corner?

When are mechanical drawings used in construction plans?

Where on a blueprint should one look to see what the symbols mean?

Why is an isometric drawing used in construction plans?

If Matthew needs to use a blueprint view that shows the building as if it were cut in two to see the wall parts, he should look at the: 

Jane needs to set the nails she uses to construct her wood project. What kind of nails should she use?

What type of screw is used with expansion shields to fasten wood to masonry materials?

What type of bolt has threads similar to a wood screw?

What type of nail has a flat head and diamond-shaped points?

Which is the best tool to cut a "V" in wood so that the top of a flat head screw will be flush with the wood or just below its surface?

What type of bolts should be used as fasteners for lightweight metal structures?

A fastener that has a hex or square head and a shank threaded about 1" is a:

If one is unable to use joist hangers to install floor joists, what has to be cut and nailed for the joists to rest on?

When a builder is using platform framing, the subfloor is nailed to the:

If one end of a stud is nailed to the sole place, where should the other end be nailed?

When Sheri is framing a building, sills are installed:

Because extra strength is needed for support, most framing lumber used for wood buildings should be:

The unit length of a rafter is the length without the:

What are the horizontal parts of a building's framing to which the studs are attached?

What is the major advantage of using metal framing anchors?

When a carpenter frames a building using platform framing, the floor joist header is installed:

If a carpenter is marking and cutting short studs to install above or below a window, he is making: 

If Johnathan goes to the building supply store and asks for hurricane ties, what is he purchasing?

When lumber is used for the horizontal parts of framing, where should the crown of a warped board be located?

Trimmer studs for doors are installed:

The seasonal nature of agriculture plays a major role in what area when one is considering a construction or repair job?

Engineered strands, flakes, or wafers cut from small wood logs and glued together by waterproof glue to make 4' x 8' panels are:

The grade of interior plywood with the best face and worst back is:

If John constructs a project that will be exposed to the weather, he should use paint or treated wood for:

What common grade lumber has loose knots, occasional knotholes, and a limited amount of pitch and season checking?

Joey is building a new livestock shelter and wants to estimate the cost. What is the most helpful for him to use?

The number of square feet of materials needed to cover four 10-foot high walls of a building 30 feet wide and 70 feet long is:

What is the unit of measurement of electrical pressure?

What is the amperage rating of an electrical device that uses 8 kilowatts of electricity when operated for 10 hours in a 120-volt circuit? (Formula: A = W divided by V)

A current-carrying outdoor under electrical pressure is a/an: 

If the local rate for electricity is $0.13 per kilowatt-hour, how much should the electric bill be for 120 kilowatt-hours? 

What is a device used to protect circuits from an overload of current?

If electricity costs $0.15 per kilowatt-hour, how much does it cost to operate a router that requires 7.5 amperes of electricity and is used in a (Formula is W = V x A)

What is the term to describe the material that stops the transfer of electricity?

A fuse is a:

A portable saw requiring 7.5 amperes of electricity is designed to be used in a 120-volt electrical circuit. How many kilowatts of current does (Formula: W = V x A)

If a local rate for electricity is $0.10 per kilowatt-hour, how much does it cost to operate an electric motor requiring 10 amperes of electricity (Formula: W = V x  A)

How many watts will be used in 10 hours if an electric motor requires 7.5 amperes of electricity and is on a 120-volt electrical circuit? (Formula: W = V x A)

Outdoor wire classified as UF is used to:

Toggle, mercury, silent, rocker arm, and push button are types of: