What to mark: Identify the 3 levels we have on Road Level.

What to mark: This level has a clarity level of the lane mark -  clear and strong it is on the road.

What to mark: This level has a lane mark that can’t be seen clearly on the road.

Because of a crack in the road going through it or the paint is washed out etc

What to mark: This LEVEL uses this attribute if you’re not sure whether it’s low or very low, don’t use it if you can’t see a lane mark at all.

What to mark: Identify the 3 Crossing attribute that refers to the location of the host vehicle in regard to the host lane Marks / next lanes.

What to mark: this Crossing attribute used as the host vehicle is switching lanes

What to mark: This crossing attribute use when the host vehicle are on the lane mark.

What to mark: This crossing attribute is use when the host vehicle is driving close to one of the lane marks on either side.

What to mark: This attribute should only be used in situations where there is definite or potential construction

Put the label on their attributes accordingly. |

Instructions: "Click one label" then, "Click the attribute that you think it belongs"

Identify and choose The Clip/Frame that has ConsArea in the image below.

Identify and choose The Clip/Frame that has ConsArea in the image below.

Identify and choose the Frame/clip that is not ConstArea true in the image below.

Please Identify the Correct label for each attribute|

Instruction: "Click the label "and then "click the attribute you think it belongs"