What is the primary purpose of an early warning system for earthquakes?

To alert people before shaking begins

To measure the earthquake's depth

Earthquake hazards

Earthquake Hazards There are so many things that can happen during or after an earthquake. There are surface rupture and physical damage to buildings and other infrastructures, liquefaction, fire, landslide, and tsunami. Surface rupture and physical damage is the most obvious hazard of an earthquake the ground to break and buildings to collapse. Urban areas would experience more Earthquakes with higher energy create stronger ground motion, which can cause of this damage due to the presence of more infrastructures. Liquefaction occurs in areas where the soil becomes saturated with water. During an earthquake, the movement of the ground may loosen the soil and allow more water to seep in between the particles. This decreases the ability of the soil to support structures that are resting upon it. When it can no longer support a building, instead of being toppled over, the building starts to sink. Liquefaction mostly occur in reclaimed lands, which were once a part of a body of water. Fires can break out during or after an earthquake due to damaged or broken utility lines, substations, and power plants. It can also occur when ground rupture breaks gas tanks or pipes that lead to gas leaks. Tsunami or a harbor wave is an earthquake hazard that is generated when earthquakes occur on the seafloor. Tsunami displaces large volume of water from the sea to the land, causing damages in the cities and communities near the shore (figure 4-2).

Earthquake Hazards There are so many things that can happen during or after an earthquake. There are surface rupture and physical damage to buildings and other infrastructures, liquefaction, fire, landslide, and tsunami. Surface rupture and physical damage is the most obvious hazard of an earthquake the ground to break and buildings to collapse. Urban areas would experience more Earthquakes with higher energy create stronger ground motion, which can cause of this damage due to the presence of more infrastructures. Liquefaction occurs in areas where the soil becomes saturated with water. During an earthquake, the movement of the ground may loosen the soil and allow more water to seep in between the particles. This decreases the ability of the soil to support structures that are resting upon it. When it can no longer support a building, instead of being toppled over, the building starts to sink. Liquefaction mostly occur in reclaimed lands, which were once a part of a body of water. Fires can break out during or after an earthquake due to damaged or broken utility lines, substations, and power plants. It can also occur when ground rupture breaks gas tanks or pipes that lead to gas leaks. Tsunami or a harbor wave is an earthquake hazard that is generated when earthquakes occur on the seafloor. Tsunami displaces large volume of water from the sea to the land, causing damages in the cities and communities near the shore.

DRRR - Grade 11 Quarter 3 - Earthquake Hazards

Tectonic hazards - Haiti earthquake 2010

Hazards of Earthquake

Geologic Processes. Where do geologic hazards usually occur? From the previous chapter, it has been discussed that the surface of Earth is made up of lithospheric plates that are moving on top of the asthenosphere. These movements along the different kinds of plate boundaries are the cause of the natural geologic phenomena such as earthquakes and volcanic eruptions. Earthquakes An earthquake is the minimal to rapid shaking of the ground due to the movement of rocks along fractures, known as faults, on Earth's surface. These faults are usually associated with the parallel movement of plates in a transform fault. As the plates move, rock deformation occurs and energy starts to build up. When the rocks break, energy is released, resulting in an earthquake. The Philippines is prone to earthquakes because of the numerous faults within the country. Therefore, it is already given that the Philippines would experience a lot of geologic hazards.

Volcanic Eruptions Earthquakes are sometimes used in predicting volcanic eruptions. An earthquake alerts the authorities to observe a nearby volcano. When a volcano shows signs of eruption, evacuation of the nearby villages should be immediately implemented Active volcanoes are the ones that are usually closely monitored by volcanologists These are commonly located along plate boundaries specifically along the Pacific Ring of Fire. The Philippines is one of the countries that have a lot of volcanoes. The Pacific Ring of Fire is a region in the Pacific where most active volcanoes are located. The dots in the figure represent the active volcanoes in the world. Active volcanoes are those that have a recorded volcanic eruption in their history. There are two types of volcanic eruptions depending on the magma composition: the explosive type and the Hawaiian or nonexplosive type. The types of eruptions depend on the viscosity and amount of dissolved gases in a magma. Explosive eruptions have magma that is highly viscous and contains large amounts of dissolved gases. On the other hand, the Hawaiian type or nonexplosive eruptions have magma that has low viscosity and low amount of dissolved gases. Viscosity determines the ability of magma to flow. The lower the viscosity, the easier it is for the magma to flow. This viscosity of the magma is affected by silica content and temperature. Low-temperature magma with high silica content are highly viscous, high-temperature magma with low silica content has low viscosity. Therefore, in explosive eruptions, the magma could not easily get out of the vent. This impedes the remaining magma below, causing an increase of pressure. Once the pressure is released. an explosive eruption occurs. Volcanic Hazards Explosive volcanic eruptions release pyroclastic flows and materials that are considered to pose the greatest threat. The pyroclastic flows often render people in a shock state since they become overwhelmed with what they are seeing Too much pyroclastic material (eg., tephra), may bury people and severely damage the agricultural land and livestock. Damaged agricultural land could lead to famine. After an eruption, pyroclastic materials that have settled along the slope of the volcano get mixed with rainwater. This would start a mudflow or lahar moving at high speed, destroying everything along its path. Poisonous gases are also released by volcanoes. These gases can be lethal to people, animals, and plants. Just like earthquakes, violent volcanic eruptions may also happen underwater, which can trigger a tsunami.

EARTHQUAKE HAZARD

Related quizzes

Related quizzes