Test I

Direction: Read the questions carefully, and choose the letter of the best answer. Shade the letterof the correct answer on your answer sheet.

1. A device used for holding a light bulb or lamp.

This material is made of multiple strands joined together to make a single wire.

A protective device used to automatically blow and cuts the current when short circuit or overload occurs.

A tool used for removing insulation of medium sized wires ranging from gauge #10 to gauge #16

This tool used for cutting and holding wires and also reach tight space or small opening where other pliers cannot reach.

It is used to cut metal conduit and armored cable.

This tool has a cross tip resembling a positive(+) sign. This is used to drive screws with cross slot heads.

A hammer with a rounded end opposite the face, a type of peening hammer used in metal workings.

This material is a measuring tool used to measure the length of an object in centimeter and inches.

This equipment is also called as__________________. It is used to measure the voltage, resistance and current of a circuit.

The following is a type of wiring diagram except one which is it?

Joey want to install a "one lamp controlled by one gang switch using circuit breaker" he already draw the schematic diagram of the circuit. What will be the next diagram he should draw?

How many inches are there in 2 feet?

It is a scale diagram of the arrangement of rooms in one story of a building that can view from above.

Test III.

“Leigh would like to replace a single pole wall switch that was installed in their Garage because its already broken", what will be the first  step he should do?

“Leigh would like to replace a single pole wall switch that was installed in their Garage because its already broken", what will be the second step he should do?

Lisa want to used the best equipment that will be accurate to measure all the current, voltage and resistance. What will be the best equipment to choose?

All of the following is a type of pliers except one which is it?

Electrical materials used to hold and anchor electrical conduits in its proper position.

What is the difference between the schematic diagram and actual diagram

Anna like to see the actual connection of the terminal that she was going to install. What type of diagram she need to see?

John have an assignment about electrical symbol of a battery, because he will draw it in the form of schematic diagram. Choose the letter of the correct electrical symbol of a battery.

To create a simple circuit in schematic diagram, what are the electrical symbol you need to draw?

What is the electrical symbol switch in the "ON" position?

Jake was asked by his supervisor to check for the voltage in the circuit. Which of the following can help her?

This is used where the tap wire is under considerable tensile stress circuit.

Your employer must conduct hazard assessment in order to

What is the definition of a Rat tail?

You are inside the EIM laboratory and somehow accident happen. Who should know first about the accident that happen inside the laboratory?

What is the meaning of OSH?

What type of material gives the wire extra protection when installing?

Bill heard a loud explosion in a nearby factory. There was an overload in the electrical source. What material serves as a circuit protective device that automatically blows and cut the current when overloaded?

Miley always uses her volt ohmmeter in her job. In order to preserve the life of her volt ohmmeter, which of the following should she do?

The main or largest room where the owner of the house can rest.

A covered shelter projecting in front of the entrance of a building.

An area containing tables or counters open to the public and designed, established, or regularly used for consuming food or drink 

The most dangerous place to use electrical equipment is?

It is the responsibility of all employees to understand and use electrical safety everyday

Which of the following is the correct  actual drawing of  " Three lamps controlled by individual switches using circuit break" in a parallel circuit?.

What is the difference between line diagram and actual diagram?