What types of wiring method is commonly found in old homes?

These are used to support wires smaller than No.8.

These are used to support or anchor wires as big as No.8 or bigger.

In the exposed knob and tube wiring method, what is the minimum distance to be observed between conductors?

This is commonly used electrical wiring conduit now a days due to its economic value.

What type of switching controls a bulb in two different locations?

This is a type of wiring installation which is designed to lessen or eliminate fire hazard and electrical accident.

This is one of the most commonly used conduits in electrical wiring installation today.

It is designed to protect the electrical wiring of building from electrical hazard due to faulty wiring.

They are reistant to impact and crushing and they do not easily get out of shape.

It is the type of metal conduit which is designed to lessen or eliminate fire hazard.

What is the process wherein rough edges or burrs at the end of non- metallic conduit shall be trimmed inside and outside?

How many millimeters thick of PVC should be installed under driveways and parking lots of single and two family dwellings?

This is less than 90°bend, it is used when the conduit crosses an obstacle or when the conduit is entering an electrical box.

This materials is used as the passage of wires for protection and insulation.

Conduit is cut with _____.

It is the allowable number of quarter bends which can be done in a one run o0f electrical metallic conduit.

What type of switching controls a bulb in two different locations?

It is a process of removing sharp edges or burrs left after cutting the pipe.

It is a type of condulet which makes conduit run turns to the right.

It is the type of bend which make one quarter turn.

It is the type of fitting which is used to secure EMT to metallic boxes.

It is the standard length of Rigid Mettalic Conduit.

What type of bend is used when the conduit runs across circular object like pipes?

What is used as a mechanical protection for electric conductors, has a smooth interior and a wall of non- conduting fibrous material?

What is the process wherein rough edges or burrs at the cut ends of nonmetallic conduit shall be trimmed inside and outside?

What is the maximun size of rigid nonmetallic conduit that the PEC required to be installed in wiring installation?

What is the minimum burial depth of PVC directly buried undergorund in a 50mm thick concrete trench?

A smooth inner surface with integral reinforcement within the conduit wall

It is combination of two offset bend.

It is the size of conduit which can accommodate a maximum of 8 wires of 3.5mm2 wire.

It serves the same purpose as with the Electrical Metallic Tubing.

What type of rigid nonmetallic conduit is one of the most commonly used conduits in electrical wiring installation today?

Which of the following is NOT example of Types of EMT utility boxes and fitting?

It is the tool used to thread rigid metal conduit.

It is an enclosed conduit that form a physical pathway for electrical wiring.

Whenever wires cross each other, what electrical materials are necessary to provide protection from injury?

How many millimeters thick of PVC should be installed under streets, highways, roads and driveway and parking lots?

Which of the following is an example of Polyvinyl chloride (PVC)?

Which of the following is not part of bend defects?

A corrugated internal and external surface without integral reinforcement within the conduit wall.

Which of the following is NOT the types of Liquid tight flexible nonmetallic conduit?

The number of conductors permitted in a____ conduit shall be in accordance with the percentage fill specified.

What do you use in bending the PVC to the desired shape?

What do you use in bending EMT for Offset bend?

What type of conduit that provides maximum protection when there is mechanical damage?

Which of the following is NOT the type of EMT fitting?

It is used in temporary installation,such as construction jobs.

It is part of a hickey that where you got to apply the pressure to bend the conduit.

Part of a hickey that will help you to bend the conduit.