
PRETEST_TLE CARPENTRY 9_2ND QTR
Quiz by Jan Paulo Macuja
Tag the questions with any skills you have. Your dashboard will track each student's mastery of each skill.
What tool do we use to drive stakes?
A large, flat, often metalhead, attached to a long handle that is used to hammer the unnecessary masonry walls in the construction site.
It is use for tying the nylon string in masonry walls.
A material used as stake and batter board in staking out building lines.
It used to cut the lumber to be used as stake and batter board.
A tool with a pointed tip on the bottom, suspended from a string and used as a vertical reference line.
A tool used to measure loans and any project area. It is also used for longer distances. It ranges up to 50 meters.
It used to test the squareness of the layout.
A tool used for sharpening stakes.
A tool used to drive and pull-out nails.
It is necessary to secure from local authorities before construction activity on the site.
In the absence of established corners and boundaries, _________ Engineer’s service is required.
Cutting of trees are limited only to those that will be affected by the construction subject to issuance of permit from what Department?
One of the requirements in the construction embodied in the specifications and contract is to provide the following except for:
It is needed to apply and secure because it is necessity in all kinds of construction.
It will protect the construction activities from onlookers andstandby.
Install the stake on the ground at reasonable spacing from theline of __________.
90Ëšcorner can be accomplish with the help of the following except for:
In the absence of right triangular object, what principle shouldbe applied?
What tool is used to transfer reference points and lines to the ground?
A device used as a guide of the hand saw in cutting objects to form a miter joint.
A double bevel square used to divide an angle in a complicated work in one setting.
A tool with combination of 45 and 90 degrees in one setting.
A plain board with a 45 degrees guide fastened on top of the upper board. This device is used in designing patterns, cabinets, and the like.
A tool that is like a try square with a sliding and adjustable blade that could be set to any angle other than 90degrees.