At ALL times how far should your fingers be away from the blade

How far above your material should the blade guard on the band saw be

When using the band saw what cuts are often made to help you make a curved cut

If someone is using a machine how far away should you be from that person and the machine

it is OK to back out of a curved cut

You should ________ force a piece of wood through the band saw if the blade is dull

if there is a problem with any of the equipment the first thing you should do is

what is the last thing you should do when you are finished using the band saw

when using the drill press you should always clamp your material to the table

on the drill press there are marks on the table how did this happen

all hair that is past your _________ should always be tied up when using any equipment in the woodshop

to prevent blowout on the drill press you should

the ________ bit on the drill press is the more difficult to cut

what tool is used to tighten and loosen a drill bit

when you are finished using the ________ it is common courtesy to brush off the table and put away your drill bit in the proper case

When using the joiner how many inches should you keep your hands away from the cutter edge.

The orange push block should ____ be placed below the blade guard.

Where the orange push block should be placed.

Infeed, Cutter Head, out feed

The number of turns of the planer hand wheel you should do for each pass.

The minimum length of material that can be passed through planer.

The minimum thickness that can be passed through planer.

What is the first thing you should if material gets stuck under planer while it is running.

The direction you should move material across the router table.

The part of the router that hols the router bit in place.

When routing straight edges on material.

The direction the router bit spins.

The router table use a _________ router.

The width of the blade of the miter saw.

You should always have ____ hand on the handle and _____ hand on the material when using the miter saw.

The smallest length of material you can cut using the miter saw.

When using the miter saw keep material ______ to fence.

To adjust the pivoting neck of miter saw.

It is better to cut ______ than short.

Use this when cutting a long piece of material.

Minimum length of material for joiner.

Position for using the table saw.

Don't need a push block or stick when the using this distance on table saw.

It is never _______ to get hurt.

The table saw on/off paddle is located here.