This can be solid or stranded used for wiring lighting fixtures and as terminal wires.

These are bare wires used for overhead transmission lines and for ground wires

This multi-conductor cable generally used for interior wiring installation in dry and wet locations.

A wire commonly used for wiring motorized engines and appliances with high temperature, and for switch board wiring.

Awire used for wiring electric ranges, hot water heaters, stoves and hairdryers where both heat and moisture resistance is desireable

What is the safety device which automatically cuts off current that exceeds the circuit rating?

This wire or cable has 2, 3, or 4 conductors, stranded and used for portable cords in electrical equipment.

This is the maximum operating temperature of a THHN wire.

This wire cannot be used in wet locations.

What is the equivalent diameter size of number 8 AWG wire in millimeter (mm)?

What is the equivalent diameter size of number 10 AWG wire in millimeter (mm)?

This is a multi-conductor cable generally used for interior wiring installations in dry and wet locations.

A wire commonly used for wiring motorized engines and appliances with high temperature, and for switch board wiring.

This is a flame retardant, moisture resistant wire used for building wiring installation in dry or wet locations.

This is usually bare solid or stranded conductor used for overhead transmission lines and ground wires.

It is of electrical wiring plan that contain the name and address of the owner, signature and dry seal of master electrician or electrical engineer.

It is of electrical wiring plan that consists of type of service, single phase 2-wire or 3-wire and voltage.

It is a part of the electrical wiring plan which show the number of branch of electrical circuit.

It is a technical representation of an electrical system proposed to be installed in building or house.

It is a part of wiring plan which shows the number of branch of electrical circuit.

It shows the classification of service, type of wiring method to be used and supplies and materials to be used by the contractor.

It is a plan of a room or floor of a building drawn to scale as if viewed from above.

the minimum circuit load of ___ amperes circuit breaker shall be used for light circuit.

the minimum circuit load of ___ amperes circuit breaker shall be used for convenience outlet.

Its indicate some precautionary measures against potential hazardous situation which, if not avoided, may result to minor or moderate injury.

Its indicates that a person should observe extra awareness

Its specifies hazardous situation which, if not avoided, will result to a serious injury or even death

Its means that any activity is not allowed as stated by the symbol.

Specifies a potentially hazardous situation which, if not avoided, could result to serious injury or even death.

It is the area of the house where the chandelier is usually installed.