For best results when giving a haircutting consultation, the hair should be:

In a haircut, design lines that are proportionate are created by using:

What type of hair should you NOT use a razor on because it will weaken the cuticle and cause it to frizz?

The foundation of every haircut is:

The highest point at the top of the head is the:

If you want to slim an area, you should use:

Cut the hair straight across the strand at 0 degree elevation to achieve a:

The angle or degree to which a subsection is held from the head when cutting is called:

The section of hair that determines the length the hair will be cut is the:

The amount of pressure used when combing and holding a subsection is:

What amount of tension should be used on curly hair?

What tool is used to cut hair with a softer edge?

One way that razor cutting differs from shear cutting is that:

The moveable blade of the shears is controlled by the:

When using electric clippers, the attachment that allows the hair to be cut one exact length is the:

Smaller sized cordless clippers used to remove superfluous hair from the neck are:

Parting the hair in the opposite way in which you cut it to determine the precision of the cut is called:

To cut hair with the razor, it should be held:

To thin hair with the razor, it should be held:

Combing the hair away from its natural falling position rather than straight out is called:

To allow for more control and shrinkage, very curly hair should be texturized while it is:

To accommodate a growth pattern such as a widow's peak, cowlick, or whorl when cutting, you should:

Sectioning the hair before cutting will help achieve a:

What type of guideline is used in a blunt cut?

What type of guideline is used in a uniform layer cut?

A cut in which all the hair is held at 180 degrees up from the head has:

A uniform layer cut, in which all the hair is the same length, is cut with what type of elevation?

What type of comb is often used when performing shear over comb for close tapers on the nape and sides?

Cutting with the points of shears to create texture in the hair ends is called:

If the head position is forward and down when cutting, you will create:

Removing bulk from the hair without shortening its length is called:

When using a razor, the hair should always be cut:

What haircutting technique involves cutting the hair very close to the hairline and gradually longer as you move up the head?

When using clippers, you should always work:

You should use what kind of tension on straight hair when you want precise lines?

What does the ring finger control on your shears?

Where does the pinky sit on your shears?

When should cut hair be swept?