
MEM18004 - Maintain and Overhaul Mechanical Equipment
Quiz by Kale Platzer
Tag the questions with any skills you have. Your dashboard will track each student's mastery of each skill.
Which preventative maintenance strategy uses specialised equipment to complete tasks such as vibration analysis, lubrication analysis and thermography?
Which preventative maintenance strategy involves assessing whether a piece of equipment will fail within a certain time period and then taking appropriate action to avoid that potential failure?
Which preventative maintenance strategy uses a more scheduled and comprehensive examination and restoration of machines?
Where could you find information in relation to replacing a gasket?
Which piece of equipment creates flow and moves product through a circuit?
What is used to connect two shafts together to transmit power?
What is used to change speed, torque, shaft direction or direction of rotation?
What is used to transfer drive from one pulley to another?
What could be used to stop or regulate flow of a fluid through a circuit?
What are some of the negative effects of incorrectly adjusted v-belts?
What could cause a bearing to become noisy or fail?
What could be the result of deterioration of rubber within a flexible coupling?
What could be some indications that a coupling is misaligned?
What results could be expected from loose motor bolts?
What would you take into consideration to avoid causing faults when levelling and aligning?
A bearing that is noisy, excessively hot or excessively vibrating is completely normal and not a concern
Match the consequences of incorrect adjustment or installation to the component
Where could you find information about the specifications of a replacement part?
What tools could be used to check vertical shaft/coupling misalignment?
Temperature monitoring should be done when the machine is operating under normal conditions
Why would it be beneficial to check newly fitted v-belts after they have been running under normal conditions for approximately 24 hours?
Flushing a gearbox after maintenance or an overhaul would be beneficial to flush any contaminants or debris prior to recommissioning
When tightening the hold-down bolts for a motor, they should be tightened...
What could you do to prevent a machine that you're working on from inadvertently starting?
Items such as procedures, signage, risk assessments, etc. are engineering type controls
Hazards, risks and controls could be identified by using which documents?
Place the following isolation steps into the correct order
What are some sources of energy that could be identified during the isolation process?
What could happen if you were to wear loose clothing or have long hair unrestrained near rotating equipment?
Match the PPE to it's use